Difference between revisions of "Advanced Rotor"
From Space Engineers Wiki
(→Programming) |
|||
| Line 55: | Line 55: | ||
== Programming == | == Programming == | ||
| − | Actions: 19 | + | (IMyMotorBase) |
| + | Actions: 19 | ||
Toggle block On/Off | Toggle block On/Off | ||
Toggle block On | Toggle block On | ||
Revision as of 06:33, 2 February 2015
Large Ship / Station
Advanced RotorComponents
Required
Mass (kg):
0
Integrity:
0
Build time (seconds):
20
Active power consumption (MW):
0.002
Dimensions (W x H x D):
1 x 2 x 1
Small Ship
Advanced RotorComponents
Required
Mass (kg):
0
Integrity:
0
Build time (seconds):
10
Active power consumption (MW):
0.0002
Dimensions (W x H x D):
3 x 2 x 3
- Note: What is actually built is the Stator. The rotor needs to be built separately after the stator is completed.
The Advanced Rotor is in all respects similar to the Rotor, except that it allows objects to pass through it via the Conveyor System. As of its introduction in Update 01.053, it has the same material requirement as the Rotor, so there is no disadvantage to using this over the original.
Programming
(IMyMotorBase) Actions: 19
Toggle block On/Off Toggle block On Toggle block Off Reverse Detach Attach Increase Torque Decrease Torque Increase Braking tor. Decrease Braking tor. Increase Velocity Decrease Velocity Reset Velocity Increase Lower limit Decrease Lower limit Increase Upper limit Decrease Upper limit Increase Rotor displacement Decrease Rotor displacement
Properties: 6
Torque Single BrakingTorque Single Velocity Single LowerLimit Single UpperLimit Single Displacement Single
[1.067]
